Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1989 Mazda 626 BaseFACTORY OEM SERVICE PROCEDURE
Wheel Alignment Specifications: Notes
WHEEL ALIGNMENT SPECIFICATIONS
| Application | Specification: Fraction (Decimal) | |
|---|---|---|
| Camber (Degrees) | ||
| Front | 21/64 ± 1/2 (.333 ± .500) | |
| Rear | NS | |
| Caster (Degrees) | 1 43/64 ± 3/4 (1.666 ± .750) | |
| Toe-In (Inches) | ||
| Front | 1/8 ± 1/8 (.125 ± .125) | |
| Rear | 0 ± 1/8 (0 ± .125) | |
| Toe-In (Degrees) | ||
| Front | 1/4 ± 1/4 (.250 ± .250) | |
| Rear | 0 ± 1/4 (0 ± .250) | |
| Toe-Out On Turns (Degrees) | ||
| Inner | 38° | |
| Outer | 31° | |
| Steering Axis Inclination (SAI) | 12 15/16° | |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.