1988 Mazda RX-7 Base, 2D ConvertibleFACTORY OEM SERVICE PROCEDURE

Fuel Pump Pressure

  1. With multipressure tester installed, move adapter lever so it is straight upward and note fuel pressure. Fuel pressure should be 64-85 psi (4.5-6.0 kg/cm2 ) for non-turbo models or 71-92 psi (5.0-6.5 kg/cm2 ) for turbo models.
  2. If fuel pressure is not within specification, check wiring harness and main relay operation. If these are okay, replace fuel pump.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.