1988 Mazda RX-7 Base, 2D ConvertibleFACTORY OEM SERVICE PROCEDURE

Fuel Pressure Regulator

  1. With multipressure tester installed, and engine at normal operating temperature and idling, position adapter lever toward the fuel pump side. See Figure . Note fuel line pressure.
  2. Fuel line pressure should be 28.4 psi (2.0 kg/cm2 ). On non-turbo models, disconnect vacuum hose from pressure regulator. On turbo models, install jumper wire from Orange pressure regulator control solenoid valve to ground. See Fig 1 & Fig 2 . On all models, recheck fuel line pressure.
    Fig 1: Pressure Regulator Control Solenoid Valve (Non-Turbo)
    G36011Courtesy of MAZDA MOTORS CORP.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.