Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1988 Mazda RX-7 Base, 2D ConvertibleFACTORY OEM SERVICE PROCEDURE
Inspection Signal (Turbo)
- Remove intercooler and disconnect intake air temperature sensor connector. See Fig 1 . Attach a 3500-ohm resistor across terminals of connector. Reinstall intercooler.
- Connect voltmeter across Black and Blue wire terminals of fuel pump connector. DO NOTΒ remove connector while checking voltage.
- Start and warm engine to normal operating temperature. Turn off ignition. Restart engine. Check that 12 volts exists for approximately 50 seconds and then decreases to approximately 9 volts after 50 seconds. Check fuel pump resistor relay, ECU unit and wiring harness if voltage is not correct.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
