Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Intake Air Temperature Sensor
Remove intake air temperature sensor from dynamic chamber. See Figure or Figure . Using a heat lamp, ohmmeter and thermometer, measure and record resistance of sensor at various temperatures. Refer to the INTAKE AIR TEMPERATURE SENSOR RESISTANCE specification table. Replace sensor if not within specification.
| Temperature | Ohms |
|---|---|
| 68°F (20°C) | 37,350-45,650 |
| 122°F (50°C) | 10,660-13,040 |
| 185°F (85°C) | 3150-3850 |
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
