1988 Mazda RX-7 Base, 2D ConvertibleFACTORY OEM SERVICE PROCEDURE

Crank Angle Sensor

Remove the crank angle sensor connector. Note terminal identification. See Fig 1 . Using an ohmmeter, check resistance at specified terminals. Resistance must be within specification. Refer to the CRANK ANGLE SENSOR RESISTANCE SPECIFICATIONSΒ  table. Replace sensor if not within specification.

CRANK ANGLE SENSOR RESISTANCE SPECIFICATIONS

Terminal Ohms
G1 & G2 110-210
Ne1 & Ne2 110-210
Fig 1: Checking Crank Angle Sensor Resistance
G36020Courtesy of MAZDA MOTORS CORP.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.