Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1988 Mazda RX-7 Base, 2D ConvertibleFACTORY OEM SERVICE PROCEDURE
Circuit Opening Relay
- Using voltmeter, check for voltage at terminals of circuit opening relay connector. Connect one probe to wire side of connector while connector is still plugged into the relay and the other probe to ground. Note terminal identification. See Fig 1 .
- With ignition on, 12 volts should exist at the "Fc" and "B" terminals and no voltage should exist at the "Fp", "STA" and "E1" terminals. With airflow meter measuring plate open, 12 volts should exist at the "Fp" and "B" terminals and no voltage should exist at the "Fc", "STA" and "E1" terminals.
- With ignition switch in "START" position, 12 volts should exist at the "Fp", "B" and "STA" terminals and no voltage should exist at the "Fc" and "E1" terminals.
- Using ohmmeter, check relay resistance at specified terminals. Replace relay if resistance is not within specification. See CIRCUIT OPENING RELAY RESISTANCE SPECIFICATIONSΒ table.
CIRCUIT OPENING RELAY RESISTANCE SPECIFICATIONS
| Terminals | Ohms |
|---|---|
| STA & E1 | 15-30 |
| B & Fc | 80-150 |
| B & Fp | Infinity |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
