1988 Mazda RX-7 Base, 2D ConvertibleFACTORY OEM SERVICE PROCEDURE

Airflow Meter

  1. Intake air temperature sensor and fuel pump switch are contained in the airflow meter. Determine terminal identification. See Fig 1 .
  2. Using ohmmeter, measure resistance between designated terminals. See AIRFLOW METER RESISTANCE SPECIFICATIONS  table. Reading must be within specification.
    AIRFLOW METER RESISTANCE SPECIFICATIONS

    Terminals Ohms Temperature
    E2 & Vs
    Non-Turbo 50-500 N/A
    Turbo 200-600 N/A
    E2 & Vref
    Non-Turbo 200-500 N/A
    Turbo 200-400 N/A
    E2 & THAa (1) 10,000-20,000 -4°F (-20°C)
    E2 & THAa (1) 4000-7000 32°F (0°C)
    E2 & THAa (1) 2000-3000 68°F (20°C)
    E2 & THAa (1) 900-1300 104°F (40°C)
    E2 & THAa (1) 400-700 140°F (60°C)
    E1 & Fc Infinity N/A
    (1) Intake air temperature sensor.
  3. Ensure measuring plate moves freely in airflow meter. Remaining terminals must be checked for fuel pump switch and measuring plate resistances. See Fig 1 . Attach ohmmeter to specified terminals to check fuel pump switch and measuring plate resistance. Refer to the FUEL PUMP SWITCH & PLATE RESISTANCE SPECIFICATIONS  table.
FUEL PUMP SWITCH & PLATE RESISTANCE SPECIFICATIONS

Terminals Ohms Plate Position
E1 & Fc Infinity Fully Closed
E1 & Fc 0 Fully Open
E2 & Vs
Non-Turbo 50-500 Fully Closed
Turbo 200-600 Fully Closed
E2 & Vs
Non-Turbo 50-500 Fully Open
Turbo 20-1000 Fully Open
Fig 1: Airflow Meter Resistance & Terminal Identification
G93510Courtesy of MAZDA MOTORS CORP.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.