1987 Mazda RX-7 Base, AutomaticFACTORY OEM SERVICE PROCEDURE

Relief Solenoid Valve (Turbo)

  1. Disconnect vacuum hoses from relief solenoid valve. Blow through solenoid port "A". See Fig 1 . Check that air flows from port "B". Disconnect relief solenoid valve connector from relief solenoid valve.
  2. Apply battery voltage and ground to the terminals. Blow through port "A" and check that air flows from relief solenoid valve air filter.
Fig 1: Testing Relief Solenoid Valve (Turbo)
G36885Courtesy of MAZDA MOTORS CORP.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.