Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1987 Mazda B2200 Base, 2D PickupFACTORY OEM SERVICE PROCEDURE
O2 Sensor
- Warm engine to normal operating temperature and run engine at idle speed. Connect a voltmeter between O2 sensor connector and ground.
- Increase engine speed to 4000 RPM until voltmeter reads .7 volt. Increase and decrease engine RPM suddenly several times. When engine RPM is increased, voltmeter should read .5-1.0 volt.
- When engine RPM is decreased, voltmeter should read 0-.4 volt. If voltmeter readings are not as specified, replace O2 sensor. 4) When using Self-Diagnostic Checker (49 H018 9A1 ), warm engine to normal operating temperature and run engine at idle speed. Increase engine speed to 2000-3000 RPM. Ensure self-diagnostic checker monitor light flashes more than 8 times in 10 seconds.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
Rather have a pro handle this?
A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.
Comes to youSame-day available12-month warranty
Get a Free QuoteNo obligation. See pricing before you book.