1987 Mazda B2200 Base, 2D PickupFACTORY OEM SERVICE PROCEDURE

Air Control Valve (ACV) Solenoid

Warm engine to normal operating temperature and turn engine off. Connect coolant temperature switch using a jumper wire. Connect a voltmeter between ACV Yellow wire terminal and ground. Voltmeter should read zero volt at 1500 RPM or higher. If voltage is not as specified, check ECU terminal 2J.

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.