Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1987 Mazda 626 BaseFACTORY OEM SERVICE PROCEDURE
No. 1 Air Control Valve (ACV): B2200
- Remove No. 1 ACV. Blow air into hose A. Ensure air does not emerge from hose B. If valve leaks, replace No. 1 ACV. See Fig 1 .
- With vacuum pump attached to No. 1 ACV, apply 15.6 in. Hg to valve. Blow air into hose A. Ensure air emerges from hose B. If not, replace No. 1 ACV.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
