Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1987 Mazda 626 BaseFACTORY OEM SERVICE PROCEDURE
Hot Idle COMPENSATOR
NOTE:
Hot idle compensation is an integral function of the air temperature sensor in the airflow meter.
- Bring engine to normal operating temperature. Remove upper air cleaner cover assembly. With connector attached, connect voltmeter to the air by-pass valve side of connector at terminal "E" and ground. See Fig 1 .
- Using a heat source, warm up intake air temperature sensor to more than 131Β°F (55Β°C). Ensure voltmeter shows zero volts. If voltage is found, test the intake air temperature sensor. See COMPUTERIZED ENGINE CONTROL SYSTEM section.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
