Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1986 Mazda RX-7 Base, AutomaticFACTORY OEM SERVICE PROCEDURE
Testing with Voltmeter
- Engine must be at normal operating temperature and transmission in Neutral (Park on A/T models). Using a voltmeter, check the control unit using CONTROL UNIT CHECK chart as a guide.
- When more than one Checking Condition is listed, all conditions must be checked. Connect the negative probe of voltmeter to ground and positive probe to other terminals as described.
- If a problem exists, check circuit to which terminals is connected. If circuit is normal, replace control unit.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
Rather have a pro handle this?
A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.
Comes to youSame-day available12-month warranty
Get a Free QuoteNo obligation. See pricing before you book.