1985 Mazda GLC L4-1490cc 1.5LFACTORY OEM SERVICE PROCEDURE

Front Wheel Alignment

<Front> Caster Angle +1 1/6 to +2 2/3
Caster Angle Desired + 1 11/12
Camber Angle +5/12 to +1 5/12
Camber Angle Desired 11/12
Toe -
Note: -.12 in. out to .12 in.
King Pin Inclination 12 1/6
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.