1985 Mazda GLC L4-1490cc 1.5LFACTORY OEM SERVICE PROCEDURE

Ignition Timing: Adjustments

Fig. 3 Location of timing marks:

Factory service manual diagram




1. Warm up the engine to normal operating temperature.
2. Run the engine at idle speed.
3. Using a timing light, align the yellow mark on the crankshaft pulley with the proper point on the ignition timing scale embossed on the timing chain cover, Fig. 3, by turning the distributor with the vacuum lines connected.

IGNITION TIMING: 6° BTDC

IDLE SPEED: MANUAL 850 rpm AUTOMATIC 750 rpm

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.