1985 Mazda GLC L4-1490cc 1.5LFACTORY OEM SERVICE PROCEDURE

Distributor Vacuum Control: Testing and Inspection

Fig. 5 Vacuum advance curve:

Factory service manual diagram





1. Warm up the engine fully.
2. Make sure that the idling speed and ignition timing are within specifications.
3. Gradually increase the vacuum on the vacuum advance diaphragm with a hand vacuum pump, note the amount of vacuum when advance starts.

Advance start: 0°/75 mm-Hg (2.95 in-Hg)

4. When the vacuum is further increased, the relation between the vacuum and advance should be kept within range Fig. 5.

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.