Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1985 Mazda GLC L4-1490cc 1.5LFACTORY OEM SERVICE PROCEDURE
Distributor Advance Unit: Testing and Inspection
1. Warm up the engine fully.
2. Make sure that the idling speed and ignition timing are within specifications.
IGNITION TIMING: 6° BTDC
IDLE SPEED: MANUAL 850 rpm AUTOMATIC 750 rpm
Fig. 4 Centrifugal advance curve:
3. Remove the vacuum hose from the distributor vacuum control unit and plug the hose.
4. While gradually increasing engine rpm, check changes in ignition timing with a timing light Fig. 4.
Excessive advance: Governor spring is fatigued (If the governor spring is broken, the initial advance is very quick and high).
Insufficient advance: Governor weight or cam is not operating properly.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
