1985 Mazda GLC L4-1490cc 1.5LFACTORY OEM SERVICE PROCEDURE

Transmission Position Sensor/Switch: Testing and Inspection




1. Raise and support vehicle.
2. Disconnect neutral switch electrical connector.
3. Connect circuit tester to terminals of switch.
4. On vehicles equipped with automatic transmission, start engine and run at idle, then apply brakes securely.
5. Ensure continuity when shift lever is in neutral and no continuity when shift lever is in any other position.


Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.