1985 Mazda 626 L4-2.0L DSLFACTORY OEM SERVICE PROCEDURE

Camber


FRONT




1. Raise and support front of vehicle, then open hood.
2. Remove four shock absorber mounting block to fender attaching nuts.
3. Push mounting block downward and turn it until specified angles are obtained.
4. Install four shock absorber mounting block to fender attaching bolts. Torque bolts to 22-27 ft.lbs. on 1984-87 models, 29-43 ft.lbs. on 1988 RX-7 and 34-46 ft.lbs. on 1988 626 and MX-6.




REAR

Camber is not adjustable and is set to specifications during production. Whenever camber is moved out of specified angle, check all parts of rear suspension and body alignment. Repair or replace defective part(s) as required.



Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.