1984 Mazda B2200FACTORY OEM SERVICE PROCEDURE

Fuel Injection System - Diesel: Operation: Injectors

The injection nozzles spray fuel into a prechamber as each compression stroke occurs. Nozzles can be disassembled, cleaned, and adjusted to correct improper spray patterns.

Injector opening pressure is adjusted with a shim on top of the needle valve return spring. See Fig 1 . The injector receives a high pressure pulse of fuel which forces open the needle valve allowing the fuel to pass into the prechamber.

Fig 1: Injector Injector must be free of dirt prior to reassembly.
G34650

The glow plug system uses 4 glow plugs (heaters) to assist in cold starting. When engine coolant is below 122Β°F (50Β°C), the No. 2 glow plug relay supplies full battery voltage to quickly heat the glow plugs.

When the glow plug reaches maximum temperature, relay No. 2 is turned off and relay No. 1 provides a reduced voltage to maintain glow plug temperature. When the engine starts, the glow plug system is turned off. See Figure .

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.

Rather have a pro handle this?

A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.

Comes to youSame-day available12-month warranty
Get a Free Quote

No obligation. See pricing before you book.