1984 Mazda B2000 Base, AutomaticFACTORY OEM SERVICE PROCEDURE

Cam Lift

  1. Perform steps 1) and 2) of Injection Pump Timing Adjustment. Dial indicator gauge should indicate zero. Turn crankshaft in direction of engine rotation, and read the maximum value reached by the indicator pointer.
  2. If the cam lift is less than .08" (2.2 mm), a problem exists with the cam disc or roller assembly. Bleed air from pump.
Fig 1: Checking Cam Lift Scribe intersecting lines from "A" and "B".
G34984
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.