1983 Mazda GLC BaseFACTORY OEM SERVICE PROCEDURE

Vacuum Switch

  1. The 3 vacuum switches are located on the firewall behind the carburetor. The individual switches can be identified by the wiring color code of the electrical connector. Unplug the electrical connector and vacuum hoses.
  2. Connect a vacuum source and circuit tester to each valve and check their calibration.
  3. On No. 1 switch, connect a circuit tester to the Blue/Red and Green/Yellow terminals. The switch should be off at .8 in. Hg and on at 4.3-5.1 in. Hg.
  4. Connect the circuit tester to Blue/White and Green/Yellow terminals. The switch should be off at .9 in. Hg and on at 7.5-8.3 in. Hg. No. 3 switch has the same color codes and is tested in the same manner.
  5. On No. 2 switch, connect the circuit tester to the Yellow/Green and Black terminals. The switch should be off at 1.2 in. Hg and on at 13.8-15.4 in. Hg.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready ToolsCompare Repair QuoteQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.

Rather have a pro handle this?

A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.

Comes to youSame-day available12-month warranty
Get a Free Quote

No obligation. See pricing before you book.