Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1983 Mazda GLC BaseFACTORY OEM SERVICE PROCEDURE
Electrical Component Locator: Switches
SWITCHES LOCATION
| Component | Location |
|---|---|
| Back-Up Light Switch (Man. Trans.) | On left side of transmission case. See Figure & Figure . |
| Brake Fluid Level Sensor | On brake master cylinder. |
| Brake/Stop Light Switch | On brake pedal bracket. See Figure & Figure . |
| Clutch Switch | On clutch pedal bracket. |
| Coolant Thermo Switch | On left side of radiator bottom tank. |
| Idle Switch | On carburetor linkage. |
| Inhibitor Switch (Auto. Trans.) | On right side of transmission case (left side FWD). See Figure & Figure . |
| Kickdown Switch | Under left side of dash on pedal bracket RWD). See Figure & Figure . |
| Neutral/Start Switch | On front of transaxle case right side of case RWD). See Figure & Figure . |
| No. 1 Vacuum Switch | On center of firewall. |
| No. 2 Vacuum Switch | On center of firewall. |
| No. 3 Vacuum Switch | On center of firewall. |
| Parking Brake Switch | At base of parking brake lever. See Figure & Figure . |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.