1983 Mazda 626 Base, 4D HatchbackFACTORY OEM SERVICE PROCEDURE

Water THERMO Sensor

Remove water thermo sensor from the intake manifold. Sensor will have Blue/Red and Blue/Yellow wires attached. Place sensor in water with a thermometer and heat up water gradually. Check the calibration of the sensor according to the Water Thermo Sensor Calibration Table

WATER THERMO SENSOR CALIBRATION

Resistance (Ohms) Water Temp.: Β°F (Β°C)
1000-3240 -4 (-20)
22210-2690 68 (20)
288-352 176 (80)
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.