Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1982 Mazda RX-7 GSL, Automatic TransFACTORY OEM SERVICE PROCEDURE
Engine Compression
Start and run engine until it reaches normal operating temperature. Disconnect all spark plug wires and remove 1 spark plug from each chamber. Check compression of each chamber with engine at cranking speed (250 RPM).
COMPRESSION SPECIFICATIONS
| Min. Compression Pressure | 86 psi (6.0 kg/cm2 ) |
|---|---|
| Max. Variation | 21 psi (1.5 kg/cm2 ) |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.