Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1982 Mazda RX-7 GSL, Automatic TransFACTORY OEM SERVICE PROCEDURE
Choke Switch
- Disconnect coupler from choke switch. Check continuity between numbered terminals in coupler, using an ohmmeter.
- Continuity should exist between terminals No. 3 and No. 7 when choke knob is pulled out about 0.4" (10 mm). Continuity should exist between terminals No. 6 and No. 8 when choke knob is at any position. See Figure for terminal locations.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.