Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1982 Mazda RX-7 GSL, Automatic TransFACTORY OEM SERVICE PROCEDURE
Air Pump
- With engine at normal operating temperature, inspect all hose connections for leaks. Check for pump noise and belt tension.
- Stop engine and disconnect air line at air control valve. Connect hose to a pressure gauge. Connect tachometer to engine.
- Start engine and run at idle speed. Gauge should register more than 1.64 psi (.12 kg/cm2 ) with engine at 800 RPM. If pump pressure is below specification, replace air pump.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.