Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1982 Mazda GLC L4-1490cc 1.5LFACTORY OEM SERVICE PROCEDURE
Exhaust Temperature Sensor: Testing and Inspection
SYSTEM TEST
1. Remove sensor, then wrap sensor and a thermometer with aluminum foil and place into a suitable container filled with oil.
2. Connect battery voltage and test lamp to the electrical connector sensor terminals.
3. Using a suitable heater, gradually heat the oil. Test lamp should illuminate when oil temperature is between 248-284°F, (120-140°C).
CAUTION: Do not exceed 302°F (150°C) when heating oil.
4. If sensor does not operate within specified limit, replace heat hazard sensor.
RESISTANCE
1. Disconnect electrical connector from thermo sensor.
2. Check for continuity between thermo sensor terminals using an ohmmeter.
3. If there is no continuity between terminals, replace sensor.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
