1982 Mazda B2000 BaseFACTORY OEM SERVICE PROCEDURE

All Other Models

The wipers are controlled by a lever on the right side of the steering column. As the lever is moved down, it switches the wipers to intermittent, low speed and high speed. If the lever is pulled toward the steering wheel, the washer sprays.

If the lever is pushed away from the steering wheel, the wipers sweep until it is released. The rear wiper/washer on GLC Hatchback is controlled by a rocker switch on the instrument panel. The RX7 rear wiper switch is on the console.

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.