1981 Mazda B2000 BaseFACTORY OEM SERVICE PROCEDURE

Evaporative Line Check (All Models)

  1. Disconnect evaporative hose from canister. Connect detached hose to a "U" tube type pressure gauge filled with water. SeeΒ Fig 1.
  2. Gradually apply low air pressure into "U" tube so that difference of water level should be 14" (356 mm).
  3. Then, bind the inlet of the "U" tube and leave bound for 5 minutes. If water drops no more than 1" (25 mm) after 5 minutes, evaporative line is in good condition.
Fig 1: Testing Evaporative Lines Using "U" Tube Pressure Gauge
G09313774Courtesy of MAZDA MOTORS CORP.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.