1981 Mazda B2000 BaseFACTORY OEM SERVICE PROCEDURE

3-Way Solenoid Valves (626 Only)

NOTE: Test procedure is the same for each EGR valve. Test each valve separately.
  1. Disconnect vacuum sensing tubes from solenoid valve and vacuum pipe. Blow through tube "B" shown in Fig 1. Air should pass through valve and escape through port "A".
    Fig 1: Testing Mazda 626 Three-Way Solenoid Valves
    G09313940Courtesy of MAZDA MOTORS CORP.
  2. Disconnect electrical connector and apply battery power to terminals in connector as shown in Fig 1. Blow through hose again; air should pass through valve and escape at solenoid valve air filter. If valve does not respond as outlined, replace 3-way solenoid valve.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.