Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1979 Mazda RX-7 GS, Automatic TransFACTORY OEM SERVICE PROCEDURE
Auto. Trans. & Calif. Man. Trans. Equipped Models
- Disconnect vacuum switch and connect an ohmmeter to terminals "A" and "B". Start and run engine at idle.
- Increase engine speed to 3000 RPM and keep throttle lever in this position for 2-3 seconds. Quickly release throttle and check continuity between terminals. Continuity should exist for 3-25 seconds.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.