Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1978 Mazda Cosmo Automatic TransFACTORY OEM SERVICE PROCEDURE
1975-78 Models
- Disconnect idle switch. Check continuity between switch terminals. Continuity should be as specified in IDLE SWITCH CONTINUITY table.
- If not, remove limiter cap on switch. Connect tachometer to engine. Connect ohmmeter to switch terminals No. 1 and 3. See Fig 5. With automatic transmission in Neutral, start engine.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.