Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
RX4 and Cosmo
Caster and camber angles are adjusted by changing position of shock absorber support. To adjust, remove four nuts attaching shock absorber support to fender apron. Raise front of vehicle and support with jack stands, then remove wheel on side to be adjusted.
- 2) Press shock absorber downward and change position of support according to table and Figure. Tighten shock absorber support mounting nuts. Install wheel, lower vehicle and recheck caster and camber.
| Adjustment | Variation | ||
|---|---|---|---|
| Shock Absorber Support | Caster | Camber | |
| A | 0 | 0 | 0 |
| B | 90° | 1/2 ° | 0 |
| C | 180° | 1/2° | 1/2° |
| D | -90° | 0 | 1/2° |
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
