Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1977 Mazda RX-3 Automatic TransFACTORY OEM SERVICE PROCEDURE
1976-77 Rotary Engine Equipped Models
- Locate heat hazard sensor. On passenger cars, sensor is located beneath mat, in floor of trunk. On Pickup, heat sensor is located in floor of passenger compartment.
- Remove sensor and wrap sensor and thermometer in aluminum foil. Place sensor in container of oil. See Fig 1. Connect test light and power source to sensor. Slowly heat oil. Test light should come on when temperature in foil reaches 230-260°F (100-130°C). Replace sensor if defective.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
