WARNING: This page is about a different car, the 2017 Ford Police Interceptor Utility and 2017 Ford Explorer. However, it is still accessible from the selected car via links, so may be relevant.

The chart describes specific module configuration information:

Module Name	Module Address	Programmable Module Installation (PMI) Available	Reprogram/Flash Capable	Requires Adaptive Learning or Calibration	Available Programmable Parameters
APIM	7D0	Yes	Yes	No	None
ATCM	792	No	No	No	None
ABS module	760	Yes	Yes	IVD initialization	Tire size
ACM	727	Yes	Yes	No	None
BCM	726	Yes	Yes	Ambient lighting calibration Rear view camera calibration	Auto unlock 1-5 enable/disable DRL feature (non-Police option only) Frequency selection Police dark car feature Remote start enable Tire pressure Trim switch inhibit Headlamp type Perimeter alarm
CCM	764	Yes	Yes	Radar horizontal and vertical alignment calibration	None
DSP	783	Yes	Yes	No	None
DACMC (integrated with ACM)	7D5	Yes	Yes	No	None
DDM	740	Yes	Yes	No	None
DSM	744	Yes	Yes	No	None
SCMG	712	Yes	Yes	No	None
SCME	776	Yes	Yes	No	None
FCDIM	7A5	Yes	Yes	No	None
FCIMB	7A0	No	Yes	No	None
GWM	716	Yes	Yes	No	None
GFM (SWIM)	7A1	No	No	No	None
GPSM	701	Yes	Yes	No	None
HCM	734	Yes	Yes	LED Lamp Driver Module Initialization	None
HUD module	7B2	No	No	No	None
HSWM	714	Yes	Yes	No	None
HVAC module	733	Yes	Yes	No	None
IPC	720	Yes	Yes	No	Beltminder® feature Courtesy wipe after wash Gallon display type Passenger Beltminder® Rear reverse gear wipe Remote start feature enable/disable Remote start climate setting driver seat/passenger seat/rear defrost/steering wheel
IPMA	706	Yes	Yes	Camera calibration	None
IPMB	7B1	Yes	Yes	Camera calibration	None
OCS module	765	No	No	OCS re-zero	None
PAM (integrated with BCM)	736	Yes	Yes	No	None
SCMH	713	Yes	Yes	No	None
PSCM	730	Yes	Yes	No	None
PCM	7E0	Yes	Yes	Misfire Monitor Neutral Profile Correction procedure	None
PDM	741	Yes	Yes	No	None
RTM	751	Yes	Yes	No	None
RGTM	775	Yes	Yes	No	None
RHVAC module	785	No	No	No	None
RCM	737	Yes	Yes	No	Driver Beltminder® Passenger Beltminder®
SODL	7C4	Yes	Yes	No	None
SODR	7C6	Yes	Yes	No	None
SCCM	724	Yes	Yes	No	None

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.

• Brakes feel soft, pull hard to one side, or make grinding noises.

• The engine overheats, stalls repeatedly, or misfires under load.

• You are missing required tools, torque specs, or safe lifting equipment.

• You are not confident in the next step or safety outcome.

Safety Warning

Module Configuration and Parameter Chart

Use the Manual With the Right Hardware

When to See a Mechanic