Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2019 Lincoln MKT BaseFACTORY OEM SERVICE PROCEDURE
Lane Keeping System: IPM-A
Diagnostics in this article assume a certain skill level and knowledge of Ford-specific diagnostic practices. Refer to Diagnostic Methods in Service Information for information about these practices.
| DTC | Description | Action |
|---|---|---|
| C1001:78 | Vision System Camera: Alignment or Adjustment Incorrect | DTC C1001:78 sets in the IPM-A when a new IPM-A has been installed without performing the camera alignment. The camera alignment is initiated using the scan tool. |
| B13A6:14 | Lane Departure Warning (LDW) Switch Input: Circuit Short To Ground or Open | GO to Pinpoint Test A . |
| All other DTCs | - | REFER to the DTC Chart in Rear View Mirrors . |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
