Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2019 Lincoln MKT BaseFACTORY OEM SERVICE PROCEDURE
Anti-Lock Brake System (Abs) And Stability Control
- Torque Specifications
- Description And Operation
- Diagnosis And Testing
- Anti-Lock Brake System (ABS) and Stability Control
- Notes
- DTC Chart
- Symptom Chart
- Diagnostic Routines
- Pinpoint Test A : DTC U3003:16
- Pinpoint Test B : DTC U3003:17
- Pinpoint Test C : C0020:16, 17 And 49
- Pinpoint Test D : Wheel Speed Sensor Erratic Signal DTCS
- PINPOINT TEST E : WHEEL SPEED SENSOR ELECTRICAL FAULT DTCs - FRONT
- PINPOINT TEST F : WHEEL SPEED SENSOR ELECTRICAL FAULT DTCs - REAR
- Pinpoint Test G : DTC C0040:64
- Pinpoint Test H : Stability Control Sensor Signal Failure DTCS
- Pinpoint Test I : DTCS C101A:15, C101A:16 And C101A:29
- Pinpoint Test J : DTC U0100:00
- Pinpoint Test K : DTC U0104:00
- Pinpoint Test L : DTC U0131:00
- Pinpoint Test M : DTC U0140:00
- Pinpoint Test N : DTC U0151:00
- Pinpoint Test O : DTC U0155:00
- Pinpoint Test P : DTC U3002:62
- Pinpoint Test Q : The Stability/Traction Control System Is Inoperative Or Cannot Be Disabled
- Pinpoint Test R : The Brake Vacuum Pump Runs Continuously
- Pinpoint Test S : The Brake Vacuum Pump Never Runs
- Pinpoint Test T : Steering Wheel Position Sensor Faults
- Pinpoint Test U : DTC C1A77:11
- Anti-Lock Brake System (ABS) and Stability Control
- Removal And Installation
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
