Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2019 Lincoln MKT BaseFACTORY OEM SERVICE PROCEDURE
Compressor Driver Module
- Remove the rear floor console refrigerator. Refer to RefrigeratorΒ .
-
Using a long thin screwdriver, remove the phillips screw from the compressor driver module mounting bracket.
- Disconnect the upper electrical connector from the compressor driver module.
- Rotate the compressor driver module to the right and remove from the mounting bracket.
- Disconnect the lower electrical connector from the compressor driver module.
- Disconnect the compressor driver module-to-refrigerator electrical connector.
- To install, reverse the removal procedure.
NOTE:
Do not bend the condenser tubes. The screwdriver must fit between the condenser tubes or damage may occur to the refrigerator.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
