2019 Lincoln MKC Base, AWDFACTORY OEM SERVICE PROCEDURE

Transmission Range Control Module (TRCM): Installation

  1. Position the TRCM and install the bolts.

    Torque: 18 lb.ft (25 Nm)

    GFD395259Courtesy of FORD MOTOR COMPANY
  2. Install the TRCM nut.

    Torque: 133 lb.in (15 Nm)

    GFD395257Courtesy of FORD MOTOR COMPANY
  3. Connect the electrical connector and the wiring harness retainer.
    GFD395260Courtesy of FORD MOTOR COMPANY
  4. Position the selector lever cable, install the clip and the bolt, and connect the selector lever cable to the TRCM.

    Torque: 62 lb.in (7 Nm)

    GFD395255Courtesy of FORD MOTOR COMPANY
  5. Position the degas bottle and the degas bottle hose and attach the retainers.
    GFD395254Courtesy of FORD MOTOR COMPANY
  6. Adjust the selector lever cable. Refer to: Selector Lever Cable AdjustmentΒ  .
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.