Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2017 Lincoln MKT Base, AWDFACTORY OEM SERVICE PROCEDURE
Power Transfer Unit: Specifications
Material
| Item | Specification | Fill Capacity |
| Motorcraft ® SAE 75W-140 Synthetic Rear Axle LubricantXY-75W140-QL (US); CXY-75W140-1L (Canada) | WSL-M2C192-A and GL-5 | 0.53L(18 oz) |
Torque Specifications
| Description | Nm | lb-ft | lb-in |
|---|---|---|---|
| Driveshaft-to-output flange bolts | 70 | 52 | - |
| EPAS electrical connector wiring retainer | 9 | - | 80 |
| Engine roll restrictor-to-frame bolt 3.5L GTDI | 103 | 76 | - |
| Fill plug | 20 | - | 177 |
| Front roll restrictor bracket bolts | 90 | 66 | - |
| Front roll restrictor through bolt | 103 | 76 | - |
| PTU bolts | 90 | 66 | - |
| PTU output flange nut FOOTNOTE(a) | - | - | - |
| PTU support bracket-to-engine block bolt - 3.5L GTDI | 48 | 35 | - |
| PTU support bracket-to-engine block bolts - 3.7L | 70 | 52 | - |
| PTU support bracket-to-PTU bolts | 48 | 35 | - |
| Rear roll restrictor through bolt | 103 | 76 | - |
| Rear roll restrictor-to-transmission bracket bolts | 90 | 66 | - |
| Rear subframe bolts | 150 | 111 | - |
| Steering shaft bolt | 20 | - | 177 |
| Subframe bracket-to-body bolts | 55 | 41 | - |
| Turbocharger lower bracket bolts | 48 | 35 | - |
| Turbocharger-to-lower bracket bolt | 19 | - | 168 |
(a) Refer to the procedure in this section.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
