2015 Lincoln Navigator Base, 4WDFACTORY OEM SERVICE PROCEDURE

Information System And Entertainment System - Am/Fm/Cd/Sync DTCS: FCDIM

DTC INDEX

DTC Description Action
C1001:01 Vision System Camera: General Electrical Failure REFER to Parking Aid .
U0155:00 Lost Communication With Instrument Panel Cluster (IPC) Control Module: No Sub Type Information GO to Pinpoint Test AB .
U0184:00 Lost Communication With Radio: No Sub Type Information GO to Pinpoint Test AC .
U0253:00 Lost Communication With Accessory Protocol Interface Module: No Sub Type Information GO to Pinpoint Test AD .
U0256:00 Lost Communication With Front Controls Interface Module "A": No Sub Type Information GO to Pinpoint Test AE .
U201A:51 Control Module Main Calibration Data: Not Programmed This DTC sets due to incomplete or incorrect PMI procedures. CHECK vehicle service history for recent service actions related to the FCDIM.
If there have been recent service actions with the FCDIM, INSTALL as-built data from PTS, following the diagnostic scan tool instructions under Module Programming>As-Built.
If there have been no recent service actions, INSTALL a new FCDIM. REFER to Front Controls/Display Interface Module (FCDIM) .
U2100:00 Initial Configuration Not Complete: No Sub Type Information This DTC sets due to incomplete or incorrect PMI procedures. CHECK vehicle service history for recent service actions related to the FCDIM.
If there have been recent service actions with the FCDIM, INSTALL as-built data from PTS, following the diagnostic scan tool instructions under Module Programming>As-Built.
If there have been no recent service actions, INSTALL a new FCDIM. REFER to Front Controls/Display Interface Module (FCDIM) .
U2101:00 Control Module Configuration Incompatible: No Sub Type Information This DTC sets due to incomplete or incorrect PMI procedures. CHECK vehicle service history for recent service actions related to the FCDIM.
If there have been recent service actions with the FCDIM, INSTALL as-built data from PTS, following the diagnostic scan tool instructions under Module Programming>As-Built.
If there have been no recent service actions, INSTALL a new FCDIM. REFER to Front Controls/Display Interface Module (FCDIM) .
U3000:41 Control Module: General Checksum Failure CLEAR the DTCs.
WAIT 10 seconds.
REPEAT the self-test.
If DTC U3000:41 is retrieved again, INSTALL a new FCDIM. REFER to Front Controls/Display Interface Module (FCDIM) .
U3000:42 Control Module: General Memory Failure CLEAR the DTCs.
WAIT 10 seconds.
REPEAT the self-test.
If DTC U3000:42 is retrieved again, INSTALL a new FCDIM. REFER to Front Controls/Display Interface Module (FCDIM) .
U3003:16 Battery Voltage: Circuit Voltage Below Threshold GO to Pinpoint Test AG .
U3003:17 Battery Voltage: Circuit Voltage Above Threshold GO to Pinpoint Test AH .
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.