2013 Lincoln Navigator Base, 4WDFACTORY OEM SERVICE PROCEDURE

Transfer Case: Specifications

MATERIAL SPECIFICATIONS

Item Specification Fill Capacity
Motorcraft® MERCON® LV Automatic Transmission Fluid
XT-10-QLVC
MERCON® LV 1.3-1.5L (2.7-3.1 pt)
Thread Sealant with PTFE
TA-24
WSK-M2G350-A2 -
Ultra Silicone Sealant
TA-29
- -
TORQUE SPECIFICATIONS

Description Nm lb-ft lb-in
Coil nut 10 - 89
Connector bracket bolts 10 - 89
Crossmember bolt 90 66 -
Drain plug 15 - 133
Evaporative Emission (EVAP) canister bolt 15 - 133
Fill plug 15 - 133
LH exhaust heat shield bolt 15 - 133
RH exhaust heat shield bolt 15 - 133
Shift motor bracket bolt 10 - 89
Skid plate-to-crossmember bolt 24 18 -
Skid plate-to-frame bolt 24 18 -
Transfer case bolt (1) - - -
Transfer case shift motor bolt 10 - 89
Transfer case shift motor bracket bolt 10 - 89
Transfer case-to-transmission bolt(1) - - -
Transmission mount bolt 90 66 -
Transmission mount nut 25 18 -
(1) Refer to the procedure in this service information. Refer to REMOVAL AND INSTALLATION .
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.