Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2013 Lincoln MKT Base, AWDFACTORY OEM SERVICE PROCEDURE
Charging System: Specifications
GENERAL SPECIFICATIONS
| Item | Specification |
|---|---|
| Generator - 2.0L GTDI (200 amps)Β | |
| Generator amps | 117/207 amps (max) @ 700-2, 000 engine rpm |
| Pulley ratio | 2.44:1 |
| Generator - 3.5L GTDI and 3.7L Ti-VCT (220 amps)Β | |
| Generator amps | 103/217 amps (max) @ 600-2, 000 engine rpm |
| Pulley ratio | 2.67:1 |
TORQUE SPECIFICATIONS
| Description | Nm | lb-ft | lb-in |
|---|---|---|---|
| Compressor-to-condenser discharge line bracket nut | 15 | - | 133 |
| Generator B+ nut | 17 | - | 150 |
| Generator bolts (2.0L GTDI) | 25 | 18 | - |
| Generator clutch pulley | 75 | 55 | - |
| Generator nut and bolt (3.5L GTDI and 3.7L Ti-VCT) | 47 | 35 | - |
| Generator stud | 8 | - | 71 |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
