Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2012 Lincoln Navigator RWDFACTORY OEM SERVICE PROCEDURE
Engine Ignition System - 5.4L (3V): Specifications
MATERIAL SPECIFICATIONS
| Item | Specification | Fill Capacity |
|---|---|---|
| Silicone Brake Caliper Grease and Dielectric Compound XG-3-A |
ESE-M1C171-A | - |
GENERAL SPECIFICATIONS
| Item | Specification |
|---|---|
| Base ignition timing | 10° Before Top Dead Center (BTDC) |
| Firing order | 1-3-7-2-6-5-4-8 |
| Spark plug | HJFS-24FP |
| Spark plug gap | 1.05 +/- 0.05 mm (0.039-0.043 in) |
TORQUE SPECIFICATIONS
| Description | Nm | lb-in |
|---|---|---|
| Ignition coil-on-plug bolts | 6 | 53 |
| Spark plugs | 12 | 106 |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.