2012 Lincoln Navigator RWDFACTORY OEM SERVICE PROCEDURE

Component testing procedure

COMPONENTS TESTING PROCEDURE CHART

Circuit to test Connect self-powered test light or ohmmeter to terminals Move switch to these positions A good switch will indicate
Starter relay circuit 9 and 10 Off Open circuit
Acc Open circuit
Run Open circuit
Start Closed circuit
Run/Start power circuit 1 and 9 Off Open circuit
Acc Open circuit
Run Closed circuit
Start Closed circuit
Run/Acc power circuit 5 and 9 Off Open circuit
Acc Closed circuit
Run Closed circuit
Start Open circuit
Key reminder circuit 3 and 8 Key in Closed circuit
Key out Open circuit
Run power circuit 7 and 8 Off Open circuit
Acc Open circuit
Run Closed circuit
Start Open circuit
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.

Rather have a pro handle this?

A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.

Comes to youSame-day available12-month warranty
Get a Free Quote

No obligation. See pricing before you book.