2012 Lincoln Navigator 4WDFACTORY OEM SERVICE PROCEDURE

Exhaust System: Specifications

TORQUE SPECIFICATIONS

Description Nm lb-ft lb-in
Exhaust and transmission mounting bracket cap bolt 35 26 -
Exhaust and transmission mounting bracket-to-transmission bolts 90 66 -
Exhaust dual Y-pipe catalytic converter-to-exhaust manifold nuts (1) - - -
Isolator and bracket assembly-to-frame bolts 25 18 -
RH catalytic converter-to-LH catalytic converter Torca® clamp nut 55 41 -
RH catalytic converter-to-muffler assembly bolts(1) - - -
Tail pipe-to-muffler assembly Torca® clamp nut 48 35 -
Transfer case skid plate bolts 25 18 -
Worm gear clamp 7 - 62
(1) Refer to the appropriate procedures in the service information.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.