Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2012 Lincoln MKS Base, FWDFACTORY OEM SERVICE PROCEDURE
Anti-Lock Brake System And Stability Control: Specifications
MATERIAL SPECIFICATIONS
| Item | Specification | Fill Capacity |
|---|---|---|
| High Performance DOT 3 Motor Vehicle Brake Fluid PM-1-C (US); CPM-1-C (Canada) |
WSS-M6C62-A or WSS-M6C65-A1 | 1, 000 ml (2.11 pt) |
TORQUE SPECIFICATIONS
| Description | Nm | lb-ft | lb-in |
|---|---|---|---|
| ABS module screws | 3 | - | 27 |
| Bracket-to-Hydraulic Control Unit (HCU) nuts | 8 | - | 71 |
| LH front brake tube-to-HCU fitting | 23 | 17 | - |
| LH rear brake tube-to-HCU fitting | 23 | 17 | - |
| Master cylinder primary brake tube-to-HCU fitting | 25 | 18 | - |
| Master cylinder secondary brake tube-to-HCU fitting | 25 | 18 | - |
| RH front brake tube-to-HCU fitting | 23 | 17 | - |
| RH rear brake tube-to-HCU fitting | 23 | 17 | - |
| Steering Angle Sensor Module (SASM) bolts | 1 | - | 9 |
| Wheel speed sensor bolts | 15 | - | 133 |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.