Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2012 Lincoln MKS AWD V6-3.7LFACTORY OEM SERVICE PROCEDURE
Control Assembly: Service and Repair
Heating Ventilation Air Conditioning (HVAC) Module
Removal and Installation
Without Navigation System
With Navigation System
NOTE: The HVAC module on vehicles not equipped with the navigation system option is serviced as an assembly with the message center buttons and finish panel. The HVAC module on vehicles equipped with the navigation system option is a stand-alone remote module located under the floor console front finish panel below the Audio Control Module (ACM). The climate control interface buttons are part of the Front Controls Interface Module (FCIM) and are serviced separately from the HVAC module.
All vehicles
1. Remove the RH instrument panel finish moulding.
2. Remove the LH and RH floor console finish mouldings.
3. Remove the floor console finish panel.
4. Remove the 2 selector lever trim panel screws.
5. Remove the 4 floor console cup holder screws and the cup holder.
Vehicles without navigation system
6. Position the selector lever trim panel rearward to detach it from the HVAC module.
7. Remove the 6 HVAC module screws and position the HVAC module to allow access to the electrical connectors.
8. Disconnect the 3 HVAC module electrical connectors and remove the HVAC module.
Vehicles with navigation system
9. Position the selector lever trim panel rearward to detach it (2 clips) from the floor console front finish panel.
10. Remove the 4 floor console front finish panel screws and the panel.
11. Remove the 2 HVAC module screws.
12. Disconnect the 2 HVAC module electrical connectors and remove the HVAC module.
All vehicles
13. To install, reverse the removal procedure.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
